SETUP MENU overview

Here is an overview and a short description of the setup procedure. You will get more details about each menu step in the following sections.

On MICROBEAST PLUS / ULTRA the current menu step is indicated by the LED letters. In SETUP MENU the menu LED must light constantly. If it's flashing, you're in the wrong menu!

With NANOBEAST the current menu step is indicated by number of flashes of the Status LED. In Setup Menu the Status LED will flash in blue color. Steps A to G are indicated by 1 to 7 flashes. From steps H to M onwards again there will be 1 to 7 flashes to indicate the current menu step. But here the first flash will be long.

SETUP MENU overview

Menu	Description	off	purple flashing	purple	red flashing	red	blue flashing	blue	red/blue alternating
A	Device orientation	horizontal, pins to front	vertical, pins to front	hor. inv., pins to front	vert. inv., pins to front	horizontal, pins to back	vertical, pins to back	hor. inv., pins to back	vert. inv., pins to back
B	Swashplate servos	custom		50 Hz	65 Hz	120 Hz	165 Hz	200 Hz
C	Rudder pulse width	custom		760 µs		960 µs		1520 µs
D	Rudder frequency	custom		50 Hz	165 Hz	270 Hz	333 Hz	560 Hz
E	Rudder limit					limit left		limit right
F	Rudder direction					left		right
G	Swash mixing	custom		no mixing	90°(3/4 servos)	120°	140°	135°/140°(1:1)
H	Servo directions			Servo 1		Servo 2		Servo 3	(Servo 4)
I	Cyclic directions					left/back		right/forward
J	Servo trim	neutral		Servo 1		Servo 2		Servo 3	(Servo 4)
K	Cyclic throw	neutral						Adjust to 6°
L	Collective pitch					min		MAX
M	Servo limit	Don't fly		not good		OK		perfect!
N	Governor	off				electric heli		nitro heli