Manuals:BXFbl:Radio Setup:ELRS: Difference between revisions

<translate>

<!--T:1-->

{{DISPLAYTITLE:CRSF and ELRS|noerror}}

__TOC__

<div style="clear:both"></div>

<br />

You can use CRSF only for sending control data to you BEASTX device. In this case only connect the TX line of the receiver to the DI1/IO1 port of your BEASTX device.<br />

<br />

When using a ELRS receiver make sure to enable the CRSF output using the web interface of your receiver. Using the RADIOMASTER ER-series receiver you can change the output signals of the receivers as needed. Here usually we set the CH2 and CH3 outputs of the receiver to RX and TX for the CRFS input and output. The smaller RADIOMASTER receivers only come with RX and TX outputs, so there is nothing special to do here. To access the web interface, power up the receiver, wait for one minute until the receiver flashes quickly, then connect your computer or smartphone to the new wifi network 10.0.0.1 (Password: expresslrs).<br />

<br />

<br />

In order to use your CRSF/ELRS receiver you have to scan the input type in the RECEIVER MENU of your BEASTX device and set the correct channel ordering  

for your radio system. By default the BEASTX system has a preset channel order that fits the '''AETR''' scheme of your OPENTX/EDGETX radio. If needed you can change the channel ordering in RECEIVER MENU of the BEASTX system.<br />

<br />

Push and hold the button on your MICROBEAST and power up the device. Menu LED A will flash instantly. Now release the button. Push again to start the scan process. When scan was successful, Menu LED B will show up. Now push and hold the button for 2 seconds and release in order to load the default channel assignments. If needed you can set up your telemetry devices at Menu LEDs L & M, if applicable; push button briefly to skip. Finally teach throttle failsafe position at Menu LED N by bringing the throttle in lowest position on your radio and push the button again. Now your MICROBEAST will start with init sequence. You can perform basic setup procedure in SETUP MENU when init sequence was completed. For further information about RECEIVER MENU setup, see next section. <br />

<br />

<br />

Connect the TX line of the receiver to DI1 port and power up NANOBEAST. Connect the push button to SYS port. Push and hold the button for 2 seconds, then release. The Status LED will change color or go off. Push the button again to start the scan process. When scan was successful, the Status LED will flash twice. Now push and hold the button for 2 seconds and release in order to load the default channel assignments. If needed you can set up your telemetry devices at Menus L & M, if applicable (Menu L = Status LED flashes long once and then 5 times, for Menu L 6 times); push button briefly to skip. Finally teach throttle failsafe position at Menu N (Status LED flashes long once and then 7 times) by bringing the throttle in lowest position on your radio and push the button again. Now your NANOBEAST will start with init sequence. For further information about RECEIVER MENU setup, see next section. Then perform basic setup procedure in SETUP MENU.<br />

<br />

<br />

You can also use the StudioX app to start receiver scan and perform further setup steps. In this case open the '''Control''' menu in StudioX and click the '''SCAN''' button in this menu's screen. Please note that when the RX line of the receiver is connected to SYS port, you must disconnect the receiver from SYS temporarily, switch off your radio and power cycle your device. It will then enable "normal" SYS operation for programming purpose. For further informations please refer to the StudioX instruction notes.<br />

<br />