Manuals:BXFbl:Setupmenu E TM: Difference between revisions
Jump to navigation
Jump to search
Shornstein (talk | contribs) No edit summary |
Shornstein (talk | contribs) No edit summary |
||
| (One intermediate revision by the same user not shown) | |||
| Line 6: | Line 6: | ||
<!--T:13--> | <!--T:13--> | ||
{{SHORT_QUOTE|width=90|'''Note:''' This setup step applies to BEASTX devices with "Tailmotor" firmware. If you're using a helicopter with normal servo control on the rudder, please follow the descriptions on the previous page. Make sure that you've installed the correct firmware with the feature '''Tailmotor''' enabled or disabled. If not using the '''Tailmotor firmware''', you will not be able to correctly control your tail motor as shown below and vice versa!}}<br /> | {{SHORT_QUOTE|width=90|color=#FAFAFA|border=#A0A0A0|radius=0|'''Note:''' This setup step applies to BEASTX devices with "Tailmotor" firmware. If you're using a helicopter with normal servo control on the rudder, please follow the descriptions on the previous page. Make sure that you've installed the correct firmware with the feature '''Tailmotor''' enabled or disabled. If not using the '''Tailmotor firmware''', you will not be able to correctly control your tail motor as shown below and vice versa!}}<br /> | ||
<!--T:12--> | <!--T:12--> | ||
| Line 17: | Line 17: | ||
<br /> | <br /> | ||
<br /> | <br /> | ||
The tail motor control is connected to the main throttle control. The tail motor will start automatically when the throttle is raised above 10%. When the throttle is cut, the tail motor will also be stopped after a little delay to make the landing procedure as smooth as possible.<br /> | <br /> | ||
'''The tail motor control is connected to the main throttle control.''' The tail motor will start automatically when the throttle is raised above 10%. When the throttle is cut, the tail motor will also be stopped after a little delay to make the landing procedure as smooth as possible.<br /> | |||
<!--T:20--> | |||
{{SHORT_QUOTE|width=90|'''For this adjustment, the tail motor must be running. Before proceeding with the setup, remove the tail rotor blades.'''<br /> | {{SHORT_QUOTE|width=90|'''For this adjustment, the tail motor must be running. Before proceeding with the setup, remove the tail rotor blades.'''<br /> | ||
⚠️ '''WARNING: Risk of injury!'''<br /> | ⚠️ '''WARNING: Risk of injury!'''<br /> | ||