Manuals:BXFbl:Setupmenu E TM/en: Difference between revisions
Jump to navigation
Jump to search
Updating to match new version of source page |
Updating to match new version of source page |
||
| (One intermediate revision by the same user not shown) | |||
| Line 2: | Line 2: | ||
{{TOC_BXFbl|Manuals:BXFbl:Setupmenu_E/en|Manuals:BXFbl:Setupmenu_G/en|SETUPMENU|}} | {{TOC_BXFbl|Manuals:BXFbl:Setupmenu_E/en|Manuals:BXFbl:Setupmenu_G/en|SETUPMENU|}} | ||
__TOC__ | __TOC__ | ||
<br /> | |||
{{SHORT_QUOTE|width=90|color=#FAFAFA|border=#A0A0A0|radius=0|'''Note:''' This setup step applies to BEASTX devices with "Tailmotor" firmware. If you're using a helicopter with normal servo control on the rudder, please follow the descriptions on the previous page. Make sure that you've installed the correct firmware with the feature '''Tailmotor''' enabled or disabled. If not using the '''Tailmotor firmware''', you will not be able to correctly control your tail motor as shown below and vice versa!}}<br /> | |||
When using a helicopter with tail motor instead of a rudder servo, we must set the start, idle and hover position for the motor in the next steps. Additionaly we have to make sure the rudder stick on the radio is set correctly.<br /> | When using a helicopter with tail motor instead of a rudder servo, we must set the start, idle and hover position for the motor in the next steps. Additionaly we have to make sure the rudder stick on the radio is set correctly.<br /> | ||
<br /> | <br /> | ||
{| | {| | ||
|- | |- | ||
| style="padding-left: | | style="padding-left: 10px;" |[[File:Tailmotor_s.png|x150px|none]] | ||
|} | |} | ||
<br /> | <br /> | ||
<br /> | |||
<br /> | |||
'''The tail motor control is connected to the main throttle control.''' The tail motor will start automatically when the throttle is raised above 10%. When the throttle is cut, the tail motor will also be stopped after a little delay to make the landing procedure as smooth as possible.<br /> | |||
{{SHORT_QUOTE|width=90|''' | {{SHORT_QUOTE|width=90|'''For this adjustment, the tail motor must be running. Before proceeding with the setup, remove the tail rotor blades.'''<br /> | ||
⚠️ '''WARNING: Risk of injury!'''<br /> | |||
Do not touch any rotating parts. Keep your hands, face, and body at a safe distance at all times. Ensure a clear and safe working area around the model.}}<br /> | |||
<br /> | <br /> | ||
= Step E - Motor off and idle position = | = Step E - Motor off and idle position = | ||