Manuals:BXFbl:Setupmenu overview: Difference between revisions

<translate>

<!--T:1-->

Tap rudder stick to select device orientation (change LED color). Please be very careful when choosing the orientation. A wrong orientation will cause the system to move the heli in the wrong direction!<br />

<br />

Tap rudder stick to select frequency (change LED color). Most digital servos can be used with 200Hz.<br />

<br />

<br />

Tap rudder stick to select pulse width (change LED color). Most servos run at 1520µs (or 1500µs which is nearly the same!). Special gyro servos use 760µs pulse. Usually this will be printed on the servo.<br />

<br />

Tap rudder stick to select frequency (change LED color). Most digital rudder servos can be used with 333Hz. Special gyro servos with 760µs pulse can go even higher.<br />

<br />

<br />

Use rudder stick (hold or tap) to move servo to one endpoint. Wait until LED flashes, then move all the way to the other endpoint. Wait again until LED flashes. If stick direction is inverted, use servo reverse function on radio to reverse direction.<br />

<br />

<br />

1. Move rudder left/right. Servo should move tail left/right accordingly. If stick direction is inverted, use servo reverse function on radio to reverse direction.<br />

<br />

<br />

Tap rudder stick to select swash plate type and swash mixing (change LED color). Most R/C helis use 120° eCCPM mixing. Check your heli's manual for more details.<br />

<br />

Tap rudder stick to select one servo after another. Move collective pitch on the radio and check servo directions. All servos must move the swash plate vertically together. If necessary, tap the roll/aileron stick once to reverse the direction of the selected servo. Repeat this for all servos.<br />

<br />

<br />

1. Move roll/aileron to the right and push pitch/elevator forwards. Check cyclic swashplate movement. The swash should move forwards and right as well. If direction is wrong, use servo reverse function on the radio and reverse roll or pitch channel as needed.<br />

<br />

<br />

Tap rudder stick to select one servo after another. If necessary, tap/hold the roll/aileron stick to adjust the servo center position. All servos should form a 90 degrees angle to the linkages. The swashplate must be perfectly level. Repeat this for all servos.<br />

<br />

<br />

Status LED off: Make sure blade pitch is 0.0° and swashplate is level.<br />

<br />

<br />

1. Move thrust/collective stick and check directions. If servos are moving the swashplate in wrong direction, use servo reverse function on radio to invert thrust/colelctive channel.<br />

<br />

<br />

Move thrust/collective stick on the radio to highest position. Carefully push cyclics (roll/aileron and pitch/elevator) to end positions. Check if servos or linkages are binding. If needed, tap or hold rudder stick to adjust limit.<br />

<br />

<br />

Tap rudder stick to select governor mode (change LED color). When not using the internal governor feature (Status LED off or purple), setup will end here. When using electric or nitro governor, next menu step will be step A of GOVERNOR MENU.<br />

<br />