Manuals:BXFbl:Radio Setup: Difference between revisions
Jump to navigation
Jump to search
Shornstein (talk | contribs) No edit summary |
Shornstein (talk | contribs) Marked this version for translation |
||
| Line 15: | Line 15: | ||
<br /> | <br /> | ||
<!--T:4--> | |||
=Preparing the radio system= | |||
The following setup procedure is shown on a Spektrum DX18 radio, but it's an example for any radio system!<br /> | The following setup procedure is shown on a Spektrum DX18 radio, but it's an example for any radio system!<br /> | ||
<br /> | <br /> | ||
| Line 73: | Line 74: | ||
<br /> | <br /> | ||
<!--T:11--> | |||
=Connecting the receiver= | |||
<p>Before connecting your receiver to the BEASTX device make sure that the '''receiver is bound to the transmitter''' and that it is sending control signals the servo outputs or data port. In the next section we will give give specific instructions for each radio system, choose your system below to proceed. Please also refer to the manual of your radio system to find out how to setup and use your radio system, especially how binding procedure is performed with your specific system. Also check if there is the need to perform special settings to enable the data output of the receiver in case you intend to use this output port in combination with a BEASTX system.</p> | <p>Before connecting your receiver to the BEASTX device make sure that the '''receiver is bound to the transmitter''' and that it is sending control signals the servo outputs or data port. In the next section we will give give specific instructions for each radio system, choose your system below to proceed. Please also refer to the manual of your radio system to find out how to setup and use your radio system, especially how binding procedure is performed with your specific system. Also check if there is the need to perform special settings to enable the data output of the receiver in case you intend to use this output port in combination with a BEASTX system.</p> | ||
<br /> | <br /> | ||