Hardware installation

From BEASTX Wiki
Revision as of 10:09, 16 October 2024 by FuzzyBot (talk | contribs) (Updating to match new version of source page)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search


Attach your BEASTX unit by using one of the provided 3M® gyropads at a preferably low vibrating position on your helicopter such as the gyro platform or receiver platform. You may need to choose another type of mounting pad depending on the vibration pattern of your helicopter.

The BEASTX system can be attached flat or upright on the helicopter:


Pay attention that the edges of the housing of your BEASTX unit are all parallel with the corresponding rotational axes of the helicopter!

Make sure that the mounting platform is perpendicular to the main shaft! On the other hand it's not important that the unit is directly placed on all the rotation axis (which is nearly impossible). Also it's not important that the system is placed in parallel to the ground or not.



MICROBEAST PLUS / MICROBEAST ULTRA


The servo connector pins must always point towards the front or rear of the helicopter. The small white sensor pinboard on the side must always be in line with flight direction.

   
 
flat, cover on top, servo connectors showing to front
 
flat, cover showing to bottom, servo connectors showing to front
 
upright, button at top, servo connectors showing to front
 
upright, button at bottom, servo connectors showing to front
 
flat, cover on top, servo connectors showing to rear
 
flat, cover showing to bottom, servo connectors showing to rear
 
upright, button at bottom, servo connectors showing to rear
 
upright, button at top, servo connectors showing to rear
   
 
flat, cover on top, servo connectors showing to front
 
flat, cover showing to bottom, servo connectors showing to front
 
upright, button at top, servo connectors showing to front
 
upright, button at bottom, servo connectors showing to front
 
flat, cover on top, servo connectors showing to rear
 
flat, cover showing to bottom, servo connectors showing to rear
 
upright, button at bottom, servo connectors showing to rear
 
upright, button at top, servo connectors showing to rear


NANOBEAST


The pins of SYS and DI1 must always point towards the front or rear of the helicopter. The white servo pinboard must always be positioned at a right angle to flight direction.

   
 
flat, cover on top, servo connectors showing to front
 
flat, cover showing to bottom, servo connectors showing to front
 
upright, LED at top, servo connectors showing to front
 
upright, LED at bottom, servo connectors showing to front
 
flat, cover on top, servo connectors showing to rear
 
flat, cover showing to bottom, servo connectors showing to rear
 
upright, LED at bottom, servo connectors showing to rear
 
upright, LED at top, servo connectors showing to rear
   
 
flat, cover on top, servo connectors showing to front
 
flat, cover showing to bottom, servo connectors showing to front
 
upright, LED at top, servo connectors showing to front
 
upright, LED at bottom, servo connectors showing to front
 
flat, cover on top, servo connectors showing to rear
 
flat, cover showing to bottom, servo connectors showing to rear
 
upright, LED at bottom, servo connectors showing to rear
 
upright, LED at top, servo connectors showing to rear